Top-Rated AC Service in Kochi

This common issue is typically caused by: 1) Clogged air filters restricting airflow, 2) Low refrigerant level due to a leak, 3) A dirty condenser coil blocking heat rejection, or 4) A failed starting capacitor preventing the compressor from starting. Our technician will run a complete diagnostic check to isolate the exact cause.

Common symptoms of compressor failure include: The indoor blower runs but you only hear a humming sound from the outdoor unit; the outdoor unit fan spins but the compressor does not start; or the AC immediately trips the electrical circuit breaker upon turning on. A professional technician will test the compressor windings using a multimeter to confirm.

Water leakage is usually caused by: A clogged condensate drain pipe (algae/dirt block), a cracked drain pan, ice formation on the evaporator coils due to low refrigerant, or an incorrect backward tilt of the indoor unit during installation. Flushing the drain line with pressurized water usually resolves the blockage.

Most electrical board issues (blown relays, fuses, power regulators, capacitors, or burnt tracks) can be repaired at a component level by a micro-electronics technician, saving you up to 70% of the cost of a new board. However, if the main microcontroller chip is damaged, a complete PCB replacement is necessary.

Inside the indoor unit, noises are usually caused by an imbalanced blower wheel, worn-out motor bearings, or loose plastic panels. On the outdoor unit, rattling is often due to loose cabinet screws, fan blade misalignment, or compressor vibration dampener degradation.

For standard residential homes, we recommend a general service (filter cleaning and operating check) every 3 to 6 months, and a deep pressure jet wash at least once a year. If you live in a coastal area like Koyilandy or Vadakara, more frequent cleanings are advised to prevent salt buildup on the coils.

On average, a well-maintained split AC lasts 7 to 10 years. However, in coastal zones (e.g., Beypore, Vadakara, Koyilandy), the saline air can corrode aluminum fins and copper pipes within 3 to 5 years unless protected with anti-corrosive coatings.

This smell is caused by mold, mildew, and bacterial growth inside the dark, damp indoor evaporator coil and drain pan. Running a deep anti-bacterial foam cleaning and flushing the drain pan resolves the odor.

An immediate MCB trip indicates a short circuit, usually caused by: Burnt compressor motor windings, a shorted capacitor, a shorted wiring harness in the outdoor unit, or an overloaded circuit. Do not turn the breaker back on; call a technician immediately to inspect the outdoor unit.

A split AC separates the indoor evaporator from the outdoor compressor/condenser, offering quieter operation and flexible wall mounting. A window AC is a single chassis unit fitted into a window frame or wall opening, which is easier to install but louder and limits window use.

Yes. A dirty filter blocks airflow, forcing the blower motor to work harder. This reduces the heat exchange across the cooling coils, leads to ice formation, lowers cooling output, and can increase your electricity consumption by 15%.

This is usually caused by: A thick layer of dust blocking the cooling coil fins, a clogged filter screen, or a detached/slipping blower wheel. A deep jet cleaning will wash away the clogged dirt and restore full airflow.

Yes. The outdoor unit's job is to release heat extracted from your indoor room. If the air blowing out of the outdoor unit is cool or ambient while the compressor is running, it means the heat transfer process is failing, often due to low refrigerant or a dirty indoor coil.

Running an AC with low gas causes the compressor to overheat, run continuously, and fail prematurely because refrigerant gas acts as a coolant for the compressor motor. It also causes coil icing and drops cooling capacity.

A standard diagnostic check takes 30 to 45 minutes. The technician will check electrical currents, filter condition, blower operation, coil health, and refrigerant pressures to diagnose the problem.